GN 1400 telescopic slides are installed in pairs. The stroke reaches ≈ 75 % of the nominal length l1 (partial extension). The steel end stops prevent the slide from being unintentionally pulled out or detached. If larger static or dynamic loads occur in the direction of extension, they should be absorbed by additional end stops.
The telescopic slides are delivered in pairs. They can be installed on either the left or right side due to their design. All mounting holes are easy to reach without additional auxiliary holes. Only the mounting holes are shown, but other production-related holes may be present.
Slide profile
Steel, Zinc plated, blue passivated finishZB
Balls
Rolling bearing steel, hardened
Ball cage
Steel, zinc plated
Operating temperature -4 °F to +212 °F
(-20 °C to +100 °C)
RoHS
Other lengths and hole distances
Other mounting options
With rubber stop
With locking device
(in retracted and / or extended position)
Other finishes
With support bracket
With retraction damping, external
| A | Without rubber stop |
| 1 | Mounting with through holes |
| l1 | l2 +0.08 / -0.08 Stroke | l3 | Fs per pair at 10,000 cycles | at 100,000 cycles |
|---|---|---|---|---|
| 11.81 | 8.27 | 19.09 | 49.46 lbf (220 N) | 38.22 lbf (170 N) |
| 13.78 | 9.45 | 22.24 | 58.45 lbf (260 N) | 44.96 lbf (200 N) |
| 15.75 | 11.42 | 26.18 | 58.45 lbf (260 N) | 44.96 lbf (200 N) |
| 19.69 | 14.57 | 33.27 | 62.95 lbf (280 N) | 49.46 lbf (220 N) |
|
|||||||||||||||||||||||||||||||||||||||||
|
Show / Hide columns
|
|||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||
|
Show / Hide columns
|
|||||||||||||||||||||||||||||||||||
|
For the listed loading forces FS to be absorbed reliably into the surrounding structure, all available through holes of the outer and inner slide must be used. Failure to use mounting screws reduces the specified load capacity accordingly. The following screws can be used for mounting: |
|||||||||||
|
Designation - Standard |
Outer slide |
Inner slide |
|||||||||
|
The maximum load capacity of telescopic slides depends on the slide cross-section and the nominal length l1 as well as the resulting stroke l2. Furthermore, the extension width, the slide materials used and the components of the equipment options, such as the dampened self-retracting mechanism, have a corresponding influence. |
|||||||||||
|
|
||||||||||
|
Wear, performance, and maximum bending were assessed after each test section. |
|||||||||||
| Min | Max | Price |
|---|---|---|
| 1 | 24 | Can$34.70 |
| 25 | 49 | Can$31.81 |
| 50 | 99 | Can$28.91 |
| ≥ 100 | Can$26.02 |
Our service team is available from Monday to Friday between 8:00 AM and 5:30 PM Eastern Time: 800-397-6993
