EN 7110 Magnetic Measuring Systems Technopolymer Plastic, for Length and Angle Measurements, with Sensor

Power supply

Lithium battery 1/2 AA 3.6 V

Battery life

3 years

Display

7-digit LCD display,
12 mm high with special character support

Reading scale

-199999; 999999

Number of decimal places

Programmable
(see operating instruction)

Units of measure

mm, inch or degrees
(programmable)

Max operating speed

1 - 5 m/s programmable (reading speed affects battery life)

Resolution

0.01 mm / 0.001 in / 0.01°

Precision

± 0.03 mm

Repeatability

0.0002 x L mm (L = value measured in mm)

Self-diagnostic

Battery check, sensor check, magnetic tape check

Reverse voltage protection

Yes

Temperature range

32 °F - 122 °F (0 °C - 50 °C)

Operating environment

Internal use

Relative humidity

Max. 95% at 77 °F (25°C) (without condensation)

One advantage of using an electronic positioning device lies in the wide range of display options of the magnetic measuring system.
The following settings can be configured with 4 multifunction keys:

• Selecting incremental or absolute measuring mode
• Changing the unit of measurement (mm, inch or degrees)
• Resetting the counter or setting an offset value
• Storage and display of 32 target positions

The lithium battery has a lifespan of over 3 years. A display symbol indicates when the battery needs to be replaced. The battery can be easily replaced by removing the rear cover. If the battery is replaced within 5 seconds, the buffer power supply prevents the loss of the configured parameters.
Other important information and instructions can be found in the operating manual. This is included with every measuring system and can be downloaded from www.jwwinco.com in the “Service” section.

1. Please use the dimensions as per the table for the cutout in the housing.

2. Deburr the cutout before inserting the display.

3. At first, insert the display at the bottom of the opening.

4. Then press in the upper part until it snaps completely into place.

1. Take out the unit by pressing down on the retaining clip at the top of the housing using a slotted screwdriver.
2. Remove the screw on the back side of the housing, and take off the cover.
3. Replace the battery, taking care to match the polarity correctly (see the position indicated on the cover). If the battery is replaced within 5 seconds, the buffer power supply prevents the loss of the configured parameters.

To ensure an accurate measurement, the distance between the sensor and the magnetic band should not exceed 1 mm. The sensor can be mounted using M3 screws.